Winsome Labs Mouse Amplifier


•Professional four-layer printed circuit board with optimized layout for low noise.
•Fault detection circuit to protect against shorts and overloads.
•Indicator LEDs for power, over-temperature, output faults, and clipping.
•All-aluminum case for shielding, ruggedness, light weight, and cool operation.
•Virtually wireless construction. The only wires are short output leads, and they are silver-plated and Teflon-insulated.


2 1/4 inches high, 4 1/4 inches wide, 5 inches deep not including
connectors and controls.

Power supply:
Switch-mode power supply included, universal input 90-264 volts AC,
47-63 Hz, IEC 320 connector and power cord included. Consumption 110
watts at full output, 8 watts standby.

Two channels, unbalanced RCA type connector, impedance > 15K ohms.

30 WPC into 8 ohms, 0.01% THD
45 WPC into 6 ohms, 0.01% THD
45 WPC into 4 ohms, 0.01% THD

Frequency response:
+/- 0.5 dB 10 - 20,000 Hz.

Voltage gain:
21 v/v (1v RMS for full output)

Still have questions? Check out our FAQ page.

 Mouse PCB
Home about us products technical information contacts